Extron-electronics MTP AV Series User Guide Bedienungsanleitung

User GuideMTP AV SeriesTwisted PairVideo and Audio Twisted Pair Transmitters and Receivers68-732-01 Rev. J 04 13

MTP AV Series • Installation 4Setting the Jumpers on New Generation NonAAP Models1. Remove and retain the four screws (two on each side of the unit

MTP AV Series • Installation 56. Locate the jumper blocks (see figure 3) on the video board. Shift the jumper to the alternate location.Transmitter

MTP AV Series • Installation 6Setting the Jumpers on AAP Transmitters1. Remove and retain the two screws that secure the back cover to the MTP (see

MTP AV Series • Installation 7Panel Features and ConnectionsTransmitter Input ConnectionsFigure 8 shows all of the combinations of video and audio in

MTP AV Series • Installation 8CAUTIONS: • The length of the exposed (stripped) portion of the copper wires is important. The ideal length is 3/16 in

MTP AV Series • Installation 9Transmitter and Receiver Throughput ConnectionsFigure 12 identifies the connections between the transmitter and receive

MTP AV Series • Installation 10TP cable terminationFigure 13 details the recommended termination of TP cables with RJ-45 connectors in accordance wit

MTP AV Series • Installation 11Power Connection (All Models)See figure 14 to identify the power connections, indicators, and panel screws.MTP Transmi

MTP AV Series • Installation 12ATTENTION: • Power supply voltage polarity is critical. Incorrect voltage polarity can damage the power supply and th

MTP AV Series • Installation 13c Captive screw audio connector (MTP R SV A, MTP R AV) — Connect a balanced or unbalanced audio device, such as an au

Safety Instructions • EnglishWARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated dangerou

MTP AV Series • Operation 14OperationThis section describes:• Front Panel Features• Troubleshooting — Skew Delay CompensationFront Panel FeaturesSHA

MTP AV Series • Reference Information 15Reference InformationThis section provides information on:• Mounting OptionsMounting OptionsNOTE: For rack,

MTP AV Series • Reference Information 16Frame Mounting (AAP Models)The MTP T AV AAP transmitters can be mounted to any Extron AAP mounting frame that

Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rule

Conventions Used in this GuideNotificationsThe following notifications are used in this guide:CAUTION: Electrical Shock that may result in injury. Us

ContentsIntroduction ... 1About the MTP Transmitters and Receivers ... 1TP Cable Advantages ...

MTP AV Series • Contents v

MTP AV Series • Introduction 1IntroductionThis section introduces the MTP transmitters and receivers. Topics discussed in this section are:• About th

MTP AV Series • Introduction 2TP Cable AdvantagesTwisted pair (TP) cable is much smaller, lighter, more flexible, and less expensive than coaxial cab

MTP AV Series • Installation 3InstallationThis section describes the installation procedures, including: • Signal Jumpers for Generational Compatibil