Extron-electronics MP 101 Series Setup Guide Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Audio-Zubehör Extron-electronics MP 101 Series Setup Guide herunter. Extron Electronics MP 101 Series Setup Guide User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Setup Guide — MP 101 Series
1
MP 101
To install and set up the MP 101, follow these
steps:
Step 1
Disconnect the MP 101 from any power source.
Step 2
Mount the MP 101 on a rack or under a desk.
N
See “Mounting the MP 101” in chapter 2.
Step 3
Connect the microphone to the MP 101 mic input. See the diagrams below for
wiring instructions.
Tip
Sleeve
Unbalanced Input
(high impedance)
Tip
Sleeve
Ring
Balanced Input
(high impedance)
(5 mm) MAX
Captive Screw
Connector strippin
g
3/16"
W
For unbalanced audio, ensure that the Phantom power switch is set to
the “off” position.
Step 4
Connect the destination device to the line output connector.
Step 5
If necessary, connect an optional Extron VCM 100 remote controller to the
remote connector.
N
See “Remote control options” in chapter 2 of the MP 101 Series User
Guide for additional information.
Step 6
Set the Mic Gain, Low Cut, Filter, and Phantom power as needed.
N
SeeAdjusting the MP 101” in chapter 2 of the MP 101 Series User
Guide for detailed instructions.
Tip
Sleeve
NO Ground Here
CAUTION
For unbalanced audio, connect the sleeve(s)
to the ground. DO NOT connect the sleeve(s)
to the negative (-) contact.
(5 mm) MAX
Captive Screw
Connector stripping
3/16"
Tip
Sleeve
Ring
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - Setup Guide — MP 101 Series

Setup Guide — MP 101 Series1MP 101To install and set up the MP 101, follow these steps:Step 1Disconnect the MP 101 from any power source.Step 2Mount

Seite 2

2Setup Guide — MP 101 Series This is a typical setup using the MP 101 preamplifi er.12V 0.5a POWER MAX MIC INPUT REMOTE VOL/MUTE MLP 101 MIC TO LINE P

Seite 3

3Setup Guide — MP 101 SeriesStep 6Connect the destination device to the MP 101 AAP line output connector. See Step 4 of this Setup Guide (page 2) fo

Seite 4

Setup Guide — MP 101 Series4© 2009 Extron Electronics. All rights reserved.Extron USA - West Headquarters+800.633.9876Inside USA / Canada Only+1.71

Kommentare zu diesen Handbüchern

Keine Kommentare