Extron electronics MDA 2V EQ Bedienungsanleitung PDF herunterladen

MDA EQ Series Setup Guide

Installation

1. Turn off and disconnect all equipment from the power source.

2. (Optional) If desired, mount the MDA EQ on a 9.5, 6, or 3.5 inch deep rack shelf; a

projector mounting pole; or furniture.

3. Connect a composite video or an S-video source device to the Input connector.

4. Connect one or two video output devices to the composite video or S-video output

connectors.

5. (Optional) Connect a monitor to the Loop-Thru connector for passive loop-through.

6. Set the termination toggle switch:

о If a monitor is connected to the Loop-Thru connector, set the

switch to High Z (up).

о If no monitor is connected, set the switch to 75 Ohm (down).

7. Wire the provided power supply as shown below and connect it to

the 2-pole, 3.5 mm captive screw connector.

Power Supply

Output Cord

Orange Captive Screw

Connector

3/16” (5 mm) MAX

SECTION A–A

Ridges

Smooth

A A

Tie Wrap

CAUTION: Always use a power supply provided by Extron for the MDA EQ series. Use of

an unauthorized power supply voids all regulatory compliance certiﬁcation and may

cause damage to the supply and the MDA.

The Extron

MDA EQ Series are compact mini distribution ampliﬁers available with

composite video or S-video and with individual output gain and equalization controls

that compensate for different cable lengths for each output. Each adjustment on the

MDA 4SV EQ model equalizes two outputs. The MDA EQ products are also line drivers,

able to equalize signals sent over 1000 feet (300 m) of Extron Mini High Resolution cable.

This guide provides basic instructions for an experienced installer to set up these

distribution ampliﬁers for operation.

VIDEO DISTRIBUTION CONTROLLER

GAIN EQ

LOOP-THRU

HIGH Z

75 Ohm

1 2

Inhaltsverzeichnis

Seite 1 - MDA EQ Series Setup Guide

MDA EQ Series Setup GuideInstallation1. Turn off and disconnect all equipment from the power source.2. (Optional) If desired, mount the MDA EQ on a

Seite 2 - GAINGAIN EQGAIN

CAUTION: The power supply must not be permanently ﬁxed to the building structure or similar structures. The power supply must not be located w

Weitere Dokumente für Audioverstärker Extron electronics MDA 2V EQ

Um das Dokument anzuzeigen Extron electronics MDA 2V EQ Bedienungsanleitung

Extron electronics MDA 2V EQ Bedienungsanleitung (2 Seiten)

Extron electronics MDA 2V EQ Bedienungsanleitung (3 Seiten)

Extron electronics MDA 2V EQ Bedienungsanleitung (19 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Extron electronics MDA 2V EQ Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Audioverstärker Extron electronics MDA 2V EQ herunter. MDA EQ Series Setup Guide Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Audioverstärker Extron electronics MDA 2V EQ

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audioverstärker Extron electronics MDA 2V EQ