Extron-electronics SW DVI A Series User Guide Bedienungsanleitung PDF herunterladen (Seite 14)

SW DVI A Series • Installation

Installation, cont’d

2-14

SW DVI A Series

To enable autoswitching,

1. Cut a small piece of wire to use as a jumper.

2. Insert the ends of the wire into pin holes 4

and 5 of the provided 5-pole captive screw

plug, connecting pins 4 and 5 together. (See

the gure at right.)

3. Use an Extron Tweeker or other small

screwdriver to tighten the plug’s two screws

above pin slots 4 and 5, so that the jumper

wire ends remain securely in place.

4. Insert the plug into the 5-pole captive screw

connector on the SW2/SW4 rear panel.

0.4A MAX

12V

POWER

INPUTS

OUTPUT

REMOTE / AUTO - SW

Remote/Auto-Sw connector with pins 4 and 5

connected by a jumper

Autoswitching remains in effect as long as the jumper wires are

connecting the two pins together.

Chapter Three

Operation

Front Panel Features

Operations

Updating Firmware

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Keine Kommentare

Extron-electronics SW DVI A Series User Guide Bedienungsanleitung Seite 14