Extron-electronics SI 3 System INTEGRATOR User Guide Bedienungsanleitung

User’s GuideCompact Full Range Surface Mount Speakers68-1261-01 Rev. A11 07SI 3 System INTEGRATOR™

8SI 3 Speakers • InstallationInstallation, cont’dWiring the speakers1. When both speakers are in place, carefully pull enough speaker wire to reach t

5. Insert the hex tool into the locking access, and slightly loosen the hex cap screw. Adjust the speaker to the desired angle (see figure 13), and t

10SI 3 Speakers • Troubleshooting TipsTroubleshooting TipsTo refit the grill:1. Carefully press the grill back into place.2. Insert and tighten down

Observed ProblemPossible Cause(s) Remedial Action1 Speaker easily lifted from mount assemblyLocking hex cap screw not tightened enoughFollowing the s

12SI 3 Speakers • SpecificationsAudio/acoustic and electrical Speaker type ... Indoor/outdoor surface mount speakerFre

Extron’s WarrantyExtron Electronics warrants this product against defects in materials and workmanship for a period of five years from the date of pur

© 2007 Extron Electronics. All rights reserved.Extron Electronics, USA1230 South Lewis StreetAnaheim, CA 92805800.633.9876 714.491.1500 FAX 714.

SI 3 Speakers • PackagingPackaging InformationFigure 1 — SI 3 speaker packaging detailsPart No.XXX-XXX-01Install 206W Ceiling Speaker33-XXXX-01 REV.

IntroductionSI 3 Speakers • Introduction1About the SI 3 SpeakersThe Extron System INTEGRATOR ™ SI 3 full range, compact, surface mount speaker is ide

SI 3 Speakers • Features2FeaturesDimensions: 8.75" H x 5.75" W x 5.61" D (22.2 cm H x 14.6 cm W x 14.24 cm D)a Bass reflex port b F

Installation3SI 3 Speakers • InstallationInstalling the SI 3 SpeakersThe Extron SI 3 speakers can be mounted on a surface, such as a wall or post, or

4SI 3 Speakers • InstallationInstallation, cont’dWall mounting applicationsInstalling the wall mount assemblyN Before starting installation, ensure t

4. Mark the wall where the wire will pass through the plate, and cut a small access hole large enough for the wire to pass through without interferen

Installation, cont’d6SI 3 Speakers • Installation6. Pull sufficient wire up through the holes in the rear plate (see figure 8) to allow ease of conne

Installation, cont’d6SI 3 Speakers • Installation6. Pull sufficient wire up through the holes in the rear plate (see figure 8) to allow ease of conne