Extron-electronics Extender Plus Series Setup Guide Bedienungsanleitung PDF herunterladen

STORE

SELECT

EDID

Extender Plus Series • Setup Guide

ATTENTION: Potential Damage to Property. Installation and service must be

performed by authorized personnel only. These products must be used with UL approved,

grounded electrical boxes.

Step 1

Conﬁgure EDID Minder at the display device. The Extender Plus models offer two ways of

conguring EDID:

• EDID Record — Enables the device to record EDID

directly from a display.

1. Turn the rotary switch (a) to position 0.

NOTE: The DIP switch positions have no

effect in this mode.

2. Apply power to the Extender by connecting the

12 VDC power supply. The green LED (b) lights

when power is available.

3. Connect the display device to the input of the Extender using a VGA cable.

4. Power on the display device.

5. Press and release the recessed EDID store button (c). The LED ashes red while

storing the EDID, then it turns solid green when the EDID data has been stored. The

display can now be disconnected.

NOTE: If an external supply was used for recording, it can now be disconnected.

• Pre-programmed EDID — The Extender Plus models contain pre‑programmed EDIDs with

the most common display native resolutions for both 50 and 60 Hz.

1. See Table 1 on page 9 of the Extender Plus Series User Guide to see which

resolution corresponds to each rotary switch (a) position. Set the rotary switch to

the native resolution of the display.

2. Set the rst DIP switch (d) to the vertical refresh frequency of the display (default is

ON, 60Hz).

Step 2

Turn all of the equipment off and disconnect the power cords from the power source.

Step 3

Select the installation location and install the electrical wall box. See “Installation

Instructions” on page 2 of the Extender Plus Series User Guide for details on installing the

wall box and cables.

NOTE: The Extron Extender Plus AAP does not require a wall box if it is installed into an

Extron HSA 400 Series or HSA 800 Series surface access product.

1 2

Inhaltsverzeichnis

Seite 1

STORE50Hz0123456789ABCDEF60SELECTEDIDaa2a4a3Extender Plus Series • Setup GuideATTENTION: Potential Damage to Property. Installation and service must

Seite 2 - Vertical sync = yellow

68‑2320‑50 Rev. A09 12Step 4Attach and wire the cables as shown in the image below. The Extender Plus D has the same circuit board configuration. See

Kommentare zu diesen Handbüchern

Keine Kommentare

Extron-electronics Extender Plus Series Setup Guide Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Extron-electronics Extender Plus Series Setup Guide herunter. Extron Electronics Extender Plus Series Setup Guide User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Extron-electronics Extender Plus Series Setup Guide