Extron-electronics MTP Series User Guide Bedienungsanleitung PDF herunterladen (Seite 10)

MTP Series • Installation 4

Setting the Jumpers on Non AAP Models

1. Remove and retain the four screws (two on each side of the unit) that secure the cover

to the MTP (see figure 1).

SHARP

GAIN

Figure 1. Removing the MTP Cover

2. For the receiver, slide the cover slightly forward to clear the front panel adjustment

knobs.

3. Lift the cover straight up.

4. If the transmitter or receiver is an audio unit, remove and retain the two screws

that secure the audio board to the main (video) board (see figure 2). Pull the audio

board back until the audio connectors clear the back of the unit and lift the board out of

the way.

NOTE: This step (4) and figure 2 are correct for either S-video or composite video

models.

Transmitter Front Panel Receiver Front Panel

Receiver Rear PanelTransmitter Rear Panel

Remove these screws.

Figure 2. Removing the Audio Board

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Keine Kommentare

Extron-electronics MTP Series User Guide Bedienungsanleitung Seite 10