Extron-electronics MTP T 15HD A User Guide Bedienungsanleitung PDF herunterladen (Seite 20)

MTP T 15HD A Architectural Series • Installation 14

EDID Minder Configuration

The MTP T 15HD A D unit supports emulation of factory-installed EDID information through

EDID Minder.

To use factory-installed EDID information:

1. If you have not already done so, connect the source device to the MTP 15HD

transmitter. Do not power on the source device at this time.

2. Set the rear panel DIP switch (see

on page 11) to the required frequency (50 or

60 Hz).

NOTE: When the rotary dial (see

on page 11) is set to position 0, the frequency

DIP switch position is ignored.

3. Set the rotary dial (see

on page 11) to the required position (see figure 15 for specific

EDID and its corresponding rotary switch position).

Positions 1 through F are factory installed. Position 0 is not used.

Rotary Switch

Position

Resolution

0 Not used

1 800x600

2 1024x768 (default)

3 1280x720

4 1280x768

5 1280x800

6 1280x1024

7 1360x768

8 1366x768

9 1400x1050

A 1400x900

B 1600x900

C 1600x1200

D 1680x1050

E 1920x1080

F 1920x1200

Figure 15. EDID Settings Table

1 2 ... 15 16 17 18 19 20 21 22

Keine Kommentare

Extron-electronics MTP T 15HD A User Guide Bedienungsanleitung Seite 20