Extron-electronics PVT Series User Guide Bedienungsanleitung PDF herunterladen (Seite 20)

Using Learn mode (available on PVT RGB D Plus only)

1. Disconnect any sources from the front panel and remove the

wallplate from the wall.

2. On the rear panel, set all the DIP switches to off (down).

3. Temporarily connect the main display device (the projector) to

the “Monitor Out” port.

4. On the front panel, the learn LED is lit solid green. Press and

release the Learn button.

5. The LED ashes red when in “learning” mode, then returns to

solid green when complete.

6. Re-install the wallplate and reconnect the source device. Connect a local display device

to the “Monitor Out” port as needed.

7. Reconnect the projector to the PoleVault switcher. Restart the source and display devices

Final installation

After testing and making any adjustments, do the following:

1. Turn off the power supply to the PoleVault switcher.

NOTE: The power to the transmitter is supplied by the PoleVault switcher.

2. Mount the transmitter into the box or mud ring, and attach the supplied Decora

faceplate to the transmitter, as shown below.

COMPUTER IN

AUDIO

MONITOR OUT

IR OUT

S G

IN OUT

Decora

Faceplate

Extron

PVT RGB D Plus (EDID)

Wall

Wall Mounting

Bracket (mud ring)

RGB output cables

Figure 16. Mounting the PVT RGB D Plus (EDID)

3. Reconnect the cables and turn on the power supply to the switcher This powers up the

wall plates.

COMPUTER IN

AUDIO

IN OUT

MONITOR OUT

IR OUT

S G

EDID Learn

Status LED

EDID Learn

Button

PVT Series • Connections and Settings 14

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Extron-electronics PVT Series User Guide Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Extron-electronics PVT Series User Guide