Setup Guide — RGB 109xi (cont’d)
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.73 39.8766
Inside Asia Only
+65.63 83.4400
+65.63 83.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.8 83.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2010 Extron Electronics. All rights reserved.
68-410-50
Rev. A
02 10
Step 6 — Connect video output
Connect a RGBHV, RGBS, or RGsB video display to the video output (
i
),
as shown in the figure at right.
Step 7 — Connect audio output
Connect an audio device to the five-pole, 3.5 mm captive screw connector
(
j
). Follow the wiring diagram below for unbalanced or balanced stereo output.
Step 8 — Connect power
Connect a standard IEC AC power connector (100-240 VAC, 50-60 Hz) to this socket (
f
).
Power on input and output devices.
Step 9 — Set rear panel DIP switches
The first three rear panel DIP switches (
h
) control:
Sync on Green (SOG) — Set to on (up) for RGsB output; set to off for RGBHV or
RGBS output.
Digital Display Sync Processing (DDSP
™
) — Set to off (down) for sync processing; set to on
(up) for no sync processing (may be needed for some LCD and DLP plasma displays) .
Serration Pulses — Set to on (up) to keep serration pulses; set to off (down) to remove them. If
there is flagging or bending at the top of the video image, set this switch to off.
N
Turning on the DDSP switch disables the horizontal shift.
Step 10 — Set rear panel Gain/Peak switch
This rear panel switch (
g
) can be set to Unity (no gain and no peaking), gain with 50%
peaking, gain with 100% peaking. For cable runs of 125 feet or less, use the Unity setting.
Step 11 — Set front panel DIP switches
These front panel ID bit termination DIP switches (
c
) must both be set to on (up) if using a
laptop and no local monitor. Both switches must be set to off (down) if using a local monitor.
Step 12 — Adjust horizontal shift
This front panel knob (
d
) adjusts the horizontal shift of the remote output display device(s).
(28 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern