Extron-electronics SMX System Setup Guide Bedienungsanleitung PDF herunterladen (Seite 23)

17SMX System MultiMatrix Switcher • Front Panel Operation

Reset Mode Table

Mode Action Result

1 Hold down the recessed

Reset button while applying

power to the switcher.

Defaults switcher to factory installed

firmware. Event scripting will not start if

the switcher is powered on in this mode. All

user ﬁles and settings (drivers, adjustments,

IP settings, and so on) are maintained (see

notes below).

3 Hold down the Reset button

for 3 seconds, until the Reset

LED blinks once, then press

Reset momentarily

(<1 second) within 1 second.

Mode 3 turns events on or off. During

resetting, the Reset LED ﬂashes 2 times if

events are starting, 3 times if events are

stopping.

4 Hold down the Reset button

for 6 seconds, until the Reset

LED blinks twice (once at 3

seconds, again at 6 seconds)

then press Reset momentarily

(<1 second) within 1 second.

Mode 4:

• Enables ARP capability

• Sets IP address to factory default

• Sets subnet address to factory default

• Sets gateway address to factory default

• Sets port mapping to factory default

• Turns DHCP off

• Turns events off

The Reset LED ﬂashes four times in quick

succession conﬁrming the Reset.

5 Hold down the Reset button

for 9 seconds, until the Reset

LED blinks three times (once

at 3 seconds, again at 6

seconds, and then again at

9 seconds). Then press Reset

momentarily (<1 second)

within 1 second.

Mode 5 performs a complete reset to

factory defaults (with the exception of the

ﬁrmware):

• Does everything mode 4 does

• Resets almost all real time adjustments:

clears all ties and presets, clears all audio

or RS-232 mutes, clears all I/O grouping,

clears all RGB delay settings to zero, and

clears all input and output audio settings

(see the SMX User Guide for more details

on these features)

• Resets all IP options

• Removes/clears all ﬁles for the SMX

The reset LED ﬂashes four times in quick

succession conﬁrming the reset.

NOTES: • After a mode 1 reset is performed, update the firmware

to the latest version. Do not operate the SMX firmware

version that results from the mode 1 reset. To use factory

default firmware, upload that version again.

• If you do not want to update ﬁrmware, or you performed

a mode 1 reset by mistake, cycle power to the SMX to

return to the ﬁrmware version that was running before

the mode 1 reset. Use the 0Q SIS command to conﬁrm

that the factory default ﬁrmware is no longer running

(look for the asterisk [*] following the version number.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Extron-electronics SMX System Setup Guide Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Extron-electronics SMX System Setup Guide