Extron-electronics TMK Series Installation Bedienungsanleitung PDF herunterladen

IMPORTANT:

Go to www.extron.com for the

complete user guide, installation

instructions, and specifications.

TMK Series • Installation Guide

The TMK series Table Mount Kits allow under-table installation for up to two single-space

AAPs (TMK120AAP) or up to three single-space AAPs (TMK130AAP). Both kits secure

to the underside of a table. The kits can also be mounted side-by-side for applications

requiring additional AAP spaces.

NOTE: The location must consider that cables are connected to the AAPs both from

the front and from the rear, and the bracket and AAPs must be readily visible to

prevent accidental contact.

ATTENTION: Do not drill through the table or furniture. If the table is too thin or of a

different material for the supplied screws, use an appropriate type and length.

USB

CHAR

USB CH

ARGER

Tighten

USB CH

ARGER

USB CH

ARGER

Install #6 x 1/2 inch wood screws

into the pilot holes.

Tighten until 1/4 inch protrudes.

Drill 3/32-inch (2.4 mm) diameter,

1/4 inch (6.3 mm) deep pilot

holes.

Mark the four keyhole locations at

the desired mounting location.

Slide the faceplate onto the screws.

Tighten the front keyhole screws only.

Connect the cables and wiring

to the AAPs.

Install the two sheet metal screws to

secure the faceplate and cover

together.

Tighten the two rear keyhole screws

through the openings in the cover.

Install AAPs in the faceplate.

(4)

Faceplate

Screws (2)

Slide the cover up and into the faceplate.

Make certain the rear slots of the cover

slide into the rear keyhole screws.

#4 x 1/4" (2)

Sheet Metal Screws

#6 x 1/2" (4)

Wood Screws

Cover

aceplate

Included Parts

Mount the TMK bracket as follows:

1 2

Included Parts 1

Inhaltsverzeichnis

Seite 1 - Included Parts

IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications.TMK Series • Installation GuideThe TMK serie

Seite 2

USB CHARGERUSB CHARGERTightenTightenUSB CHARGERUSB CHARGER1Install #6 x 1/2 inch wood screws into the pilot holes. Tighten until 1/4 inch protrudes. D