Extron electronics PVS 405D Installationsanleitung

Installation GuideVoiceLift68-2548-20 Rev. A 02 14VoiceLift Microphone SystemFeaturing PVS 405D PoleVault Digital Switcher

VoiceLift System with PVS 405D Installation Guide • Introduction4Room ConsiderationsThe following room factors are important to consider when you are

VoiceLift System with PVS 405D Installation Guide • Introduction 5Line-of-sight obstructions between microphone and receiverA clear line of sight betw

VoiceLift System with PVS 405D Installation Guide • Introduction6ReflectionLine of sight from the microphone to the receiver is ideal; however, reec

VoiceLift System with PVS 405D Installation Guide • Introduction 7Receiver LocationThe best location to mount the receiver is on the ceiling in the ce

VoiceLift System with PVS 405D Installation Guide • Introduction8PoleVault Switcher LocationThe PoleVault switcher can be mounted anywhere in the roo

VoiceLift System with PVS 405D Installation Guide • Introduction 9InventoryThe VoiceLift VLS System kit is available in three packaged congurations:

VoiceLift System with PVS 405D Installation Guide • Introduction10NOTE: If any items in the VoiceLift System or FF 120 boxes are damaged or missing,

VoiceLift System with PVS 405D • Introduction 113/4-inch Extension Bit forDrilling Through Fire BreaksPower DrillTools for Terminating CableVacuum Cl

VoiceLift System with PVS 405D Installation Guide • Introduction12Items Not IncludedThe following items are not included. However, some or all of the

Installation OverviewThis section provides an overview of the ve stages of installation for the VoiceLift system and the steps required for each stag

Safety InstructionsSafety Instructions • EnglishWARNING: This symbol, , when used on the product, is intended to alert the user of the presence of u

Stage 4 — Connect the VLR 102 Receiver to the PoleVault Systemc Pull the cables to the receiver (page 29).c Connect the cables to the receiver (page

Stage 1: Mounting the ReceiverThis stage consists of installing the VLR 102 receiver in a drop ceiling or on a wall.Receiver Housing and Back PlateRac

Stage 1d: Installing the VoiceLift Receiver on a Pole (page 21)Stage 1c: Installing the VoiceLift Receiver to a Wall (page 19)S

1. Cut a hole in the ceiling tile.a. Remove the ceiling tile in which the receiver will be installed.b. Determine the receiver location, then cut a

Stage 1b — Installing the Receiver to a Junction Box1. Install the junction box.• Install the junction or ceiling box (not included) flush with the

1. Install a raceway if needed.If using a raceway for the cables, install it at the appropriate location on the mounting surface.NOTE: Raceway knoc

4. Mount the receiver housing to the surface.If not using a raceway: Mount the receiver housing and base to the surface, using the appropriate screws

Stage 1d — Installing the Receiver on a Pole1. Attach the pole to the ceiling.Attach the required length of ¾-inch (19 mm) diameter electrical metal

Stage 2: Mounting the FF 20 SpeakersThis stage consists of installing and connecting the FF 120 speakers (VLS only).NOTE: The installation must confo

1. Cut the ceiling tile.See the FF 120 Flat Field Speaker User Guide, available at www.extron.com, for detailed instructions.a. Remove the ceiling t

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rule

PVS SwitcherRear PanelSpeaker 1 Speaker 24-pole CaptiveScrew ConnectorLR4/8OhmsAMPLIFIED OUTPUTS4-pole CaptiveScrew ConnectorAudio Outputto Speakers4.

4 Ohm Total Load4 Ohm Total LoadTwo 8 ohm speakers wired in parallel equal a 4 ohm load.LR4/8 OhmsAMPLIFIED OUTPUTSMono –orStereo R-8ohms8 oh

Stage 3: Installing the PoleVault SwitcherThis stage consists of installing the PVS 405D PoleVault Switcher (VLS only). See the PoleVault Systems Feat

PoleVault Switcher Installation1. For assistance in selecting a location for the PVS 405D switcher within the room, see Room Considerations on page 4

Stage 4: Connecting the CablesThis stage consists of connecting the receiver and speakers to the PoleVault switcher.Receiver DomeLockingTab (4)RJ-45 C

Ä Pull the cables through the receiver base. 1. Pull the cables to the receiver. a. Pull the STP cable through the receiver base, along with any ot

2. Connect the cables to the receiver (continued).b. Install any optional devices and connect their cables to the appropriate ports on the receiver

3. Attach the receiver dome to the housing (continued).b. Twist the dome to the right (clockwise) until it locks in place (approximately 1/8 turn).

LRDO NOTGROUNDOR SHORTSPEAKEROUTPUTS4/8Ω3A MAXPOWER12VHDMI1/2SIG LINK SIG LINK3/4INPUTS OUTPUT AUDIO OUTPVS 405DAMPLIFIED AUDIO OUTPAGINGSENSORPVT IN

Stage 5: Testing the SystemThis stage consists of conguring, setting up, and testing the VoiceLift System.1. Set up the microphones.Set up each micr

Conventions Used in this GuideNotificationsThe following notifications are used in this guide:CAUTION: A caution indicates a situation that may resul

1. Set up the microphones (continued).e. Attach the lanyard to the VLP 202 (pendant microphone only).i. Press the lanyard into the guides on either

~ 4 inches (10.2 mm)LanyardLanyardLockBreakawayClaspExtronPWROFF/MUTEONÉ Instructor: Place the microphone on the lanyard and adjust it. 2. Set the m

h. Lower the volume on the microphone to an appropriate level:• The level of your speaking voice should be enhanced, but not loud enough to sound li

1. Connect the receiver to the MLC 104 IP Plus.a. Wire one of the provided two-pole captive screw connectors to one end of a communication cable as

1. Connect the receiver to the MLC 104 IP Plus (continued).c. Pull the other end of the communication cable to the MLC 104 IP Plus location.d. Conn

Extron WarrantyExtron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purc

Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +

ContentsIntroduction ... 1About this Guide... 1Abo

VoiceLift System with PVS 405D Installation Guide • Contentsvi

VoiceLift System with PVS 405D Installation Guide • Introduction 1IntroductionThis section provides an overview of the VoiceLift System and gives inst

VoiceLift System with PVS 405D Installation Guide • Introduction2Application DiagramThe application diagram below shows a typical classroom installat

VoiceLift System with PVS 405D Installation Guide • Introduction 3Planning the InstallationBefore you begin the installation, consider the major facto