Extron electronics QGE 100 Betriebsanweisung PDF herunterladen (Seite 15)

QGE 100 • Installation and Maintenance 9

Rear Panel Features

COM 1

COM 2

DVI-I DVI-I

12V DC IN

REG

1.5A MAX

PERIPH PC

Refer all servicing to

qualiﬁed service personnel

1 2

Reserved for

Future Use

Figure 5. QGE 100 Rear Panel

a Power connector — Connect the provided 12 VDC power supply to this female

3-pin mini DIN connector (see “Connecting Power to the Unit” for the connection

procedure and important cautions).

b Ethernet port — Connect a straight-through patch cable between this shielded

RJ-45 port and a router or switch that is connected to your local network (see

“Connecting the QGE 100 to the Network” on page 12 for pin assignments and

instructions for connecting to this port).

c Periph (peripheral) mouse connector — This loop-through connector enables

mouse control of the source computer to pass through the QGE 100. Plug the PS/2

mouse of the source computer into this female 6-pin mini DIN connector (indicated

on the rear panel by a mouse icon located between this connector and the PC mouse

connector). (See “Connecting the Source Computer to the QGE 100”on page 10

for PS/2 port pin assignments and instructions for connecting to this port).

d PC mouse connector — Connect one of the supplied PS/2 cables from this female

6-pin mini DIN connector to the PS/2 mouse port of the source computer (see

“Connecting the Source Computer to the QGE 100” for pin assignments and

instructions for connecting to this port).

e COM 1 serial port — This port is used for advanced diagnostics by Extron personnel.

It is not intended for use during normal operation.

f DVI-I In monitor port — Connect the appropriate provided cable (DVI or analog)

between this female DVI-I port and the monitor port of the source computer (see

“Connecting the Source Computer to the QGE 100,” below, for pin assignments

and instructions for connecting to the port).

g DVI-I Out monitor port — Connect the monitor of the source computer to this

female DVI-I loop-through connector (see “Connecting the Source Computer to

the QGE 100” for pin assignments and instructions for connecting to the port).

h PC keyboard connector — Connect one of the supplied PS/2 cables from this

female 6-pin mini DIN connector to the PS/2 keyboard port of the source computer

(see “Connecting the Source Computer to the QGE 100” for pin assignments and

instructions for connecting to this port).

i Periph (peripheral) keyboard connector — This loop-through connector enables

keyboard control of the source computer to pass through the QGE 100. Connect the

keyboard of the source computer to this female 6-pin mini DIN connector (indicated

on the rear panel by a keyboard icon located between this connector and the PC

keyboard connector). (See “Connecting the Source Computer to the QGE 100”

for pin assignments and instructions for connecting to this port.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

Extron electronics QGE 100 Betriebsanweisung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Extron electronics QGE 100