Extron-electronics DVI 201xi Tx User Guide Bedienungsanleitung Seite 1

68-1645-01 Rev. B12 10DVI 201xi TxUser GuideDVI and HDMI®Single Link DVI Transmitter

Power Inputb Power input — The 12 VDC power supply (provided) connects to this two-pole, 3.5 mm captive screw connector.1. Connect the captive screw

2. Connect the AC power cord of the power supply unit to a 110 or 220 VAC electrical source.3. When the transmitter or receiver is getting power, ei

EDID Mindere EDID Minder Store switch and LED — When depressed, the transmitter reads and stores the EDID information from the local monitor. The LE

RS-232 signalsRS-232 signals are bidirectional – signals pass from the control device and replies return from the remote device. To connect the contro

1. Cut the cables to the required length. Both cables should be the same length.2. Remove about 7/8 inch (2.2 cm) of the outer coat. If using STP ca

Twisted Pair Cable ConnectionsThe DVI 201xi Tx is a single link DVI transmitter. It is compatible with all Extron single link HDMI and DVI receivers (

Configuration and OperationThis section of the user guide provides information about Conguring EDID Setup and Operation TroubleshootingCongurin

9. Connect the transmitter to the receiver with the two twisted pair cables: Transmitter port 1 connects to receiver port 1 Transmitter port 2 co

6. Boot up the source device. The source boots with the resolution and refresh rate of the local monitor.7. Power on the display device.NOTE: The r

Setup and Operation1. Determine which display device will provide the EDID information and configure the DDC switches appropriately (see DDC Switches

This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipmen

DVI signals run at very high frequency and are especially susceptible to bad video connections, too many adapters, or cables that are too long. To avo

Specications VideoMaximum data rate ... 4.95 Gbps (1.65 Gbps per color)Maximum pixel clock ... 165 MHzRes

Serial control pin configuration ... Captive screw connectors: 1 = TX, 2 = RX, 3 = GNDGeneralExternal power supply ... 100 VAC

Reference InformationThis section of the user guide provides information about: Included Parts Compatible Receivers (must be purchased separately)

MountingThis section describes the mounting options for the DVI 201xi Tx Tabletop Mounting Rack Mounting Under-desk MountingTabletop MountingAtt

Extron® WarrantyExtron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of pur

Extron USA - WestHeadquarters+800.633.9876Inside USA/Canada Only+1.714.491.1500+1.714.491.1517 FAXExtron USA - East+800.633.9876Inside USA/Canada Only

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rule

ContentsIntroduction ... 1About the DVI 201xi Tx ... 1DVI 201xi Tx Features

DVI 201xi Tx • Contents vi

IntroductionThis guide contains information about the function, installation, and operation of the Extron® DVI 201xi Tx DVI transmitter. The guide als

Control communications pass-through — The DVI 201xi Tx passes through RS-232 (two way) or IR (one way) control signals, via the connected receiver, to

Panel Features and ConnectionsThis section of the user guide describes: Front panel features Rear panel features and connectionsDVI 201xi Tx Front