Extron-electronics Cable Retraction System User Guide Bedienungsanleitung PDF herunterladen (Seite 20)

Cable Retraction System • Installation 14

CC300, CC600, CC800, TLE, TLP Installation

The enclosure must be installed and properly configured before beginning the retraction

system installation.

1. With the cable release buttons against the enclosure wall, install the retraction system

by pushing the system up and into the enclosure (see figure 13).

2. With the retraction system against the sidewall, press the mounting bolt through the

second hole from the edge of the Cable Cubby enclosure, through the retraction

system, then out the other side of the enclosure.

3. Thread the nut on the bolt and tighten.

ATTENTION: Do not overtighten the enclosure mounting bolt. It only needs

to be snug. Overtightening could deform the retractor housing and cause

misalignment of the pulley wheels resulting in malfunction.

Figure 13. Retraction System Installation

4. Connect the retraction system cables and other AAP cables (if installed).

5. If horizontally mounting the retractors, proceed to Horizontal Bracket Mounting on

page15.

For vertical and angular mounting, see Locking Screw (Optional) on page17 for

final installation details.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Keine Kommentare

Extron-electronics Cable Retraction System User Guide Bedienungsanleitung Seite 20