Extron-electronics FPC 5500 Bedienungsanleitung PDF herunterladen (Seite 18)

Extron FPC 5500 • Matrix System Operation 12

Matrix System

Operation

• Introduction

• Operating the Touch Panel

• Starting Up the Controller and Logging In and Out

• Demo Mode

• Navigating the Screens

• User Screens

• Admin Screens

• Remotes Screen

• TCP/IP Screen

• E-Mail Screen

• Miscellaneous Screen

• Setup Screens

• Subnetting — A Primer

Introduction

This section details operation of a matrix system using an FPC 5500 front panel controller.

This section assumes that the matrix is properly installed, virtualized (for Matrix 12800

systems), and operating correctly.

The FPC 5500 software runs in an FPC computer that communicates with the matrix

switcher via a Category (CAT) 5e or higher cable, terminated with RJ-45 connectors,

between the FPC Net port and either the Ethernet port on the matrix (BME 0 on a

Matrix 12800 systems) or an Ethernet LAN on which the matrix also resides.

Control of the matrix switcher via the FPC can be password protected. There are two levels

of password protection: administrator and user. Personnel logged on as an administrator

have full access to all matrix switching capabilities and editing functions. Personnel logged

on as a user can create ties, recall presets, set video and audio mutes, and view all settings

with the exception of passwords. If the same passwords or no password is required for

logging on, all personnel log on with administrator privileges. Fields and functions that

exceed user privileges are inaccessible to users from the FPC.

NOTES: • The following instructions and figures are identical for all FPC 5500

compatible matrix systems (Matrix 12800, FOX Matrix 14400, and

FOX Matrix 320x), except where noted.

• Virtual Inputs and Virtual Outputs are applicable to Matrix 12800 systems

only.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 58 59

Keine Kommentare

Extron-electronics FPC 5500 Bedienungsanleitung Seite 18