Extron-electronics HDMI 101 Bedienungsanleitung PDF herunterladen (Seite 14)

DVI 101 and HDMI 101 • Installation and Operation

Installation and Operation, cont’d

2-4

Furniture mounting

To mount the DVI 101 or the HDMI 101 under a desk top,

podium, or other furniture, use the optional MBU 125 Under-

desk Mounting Kit (part #70-077-01), as follows:

1. If rubber feet were previously attached to the bottom of the

unit, remove them.

2. Remove the screws from one side of the DVI/HDMI.

Retain the screws for possible later reassembly.

3. Attach one bracket to the side of the unit, using the

provided machine screws (see the illustration below).

Under-desk mounting the DVI/HDMI

4. Repeat steps 2 and 3 on the other side of the DVI/HDMI.

5. Hold the unit with the attached brackets against the

underside of the table or other furniture. On the mounting

surface, mark the location of the bracket’s screw holes.

6. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)

deep in the mounting surface at the marked screw

locations.

7. Insert #8 wood screws into the four pilot holes. Tighten

each screw into the mounting surface until slightly less

than 1/4" of the screw head protrudes.

8. Align the mounting screws with the slots in the brackets

and place the unit against the surface, with the screws

through the bracket slots.

9. Slide the unit slightly forward or back, then tighten all four

screws to secure it in place.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Keine Kommentare

Extron-electronics HDMI 101 Bedienungsanleitung Seite 14