Extron electronics MGP Pro Series Betriebsanweisung PDF herunterladen (Seite 11)

WindoWall Pro Series • Installation 5

Installation

This section describes the installation procedures for the WindoWall Pro Series

Multi-Graphic Processor and the connectors on the rear panel. Topics include:

• Installation Overview

• Rear Panel Features

• Front Panel

• Resetting

Installation Overview

The WindoWall Console software can control up to 16 MGPs in a videowall application. To

install and set up multiple WindoWall Processor units for a videowall, follow the steps below

(see the application diagram in figure 1 on page 4 for a connection example).

1. Disconnect power from the processors and turn off all other devices that will be

connected.

2. Install the four rubber feet on the bottom of the unit, or mount it using the supplied rack

mounting brackets (see Mounting the WindoWall Pro on page 68).

3. Attach all video sources to the input connectors of a matrix switcher, such as an Extron

CrossPoint.

4. If using HDMI inputs with the WindowWall Pro DI, connect each HDMI input source to

an HDMI distribution amplifier (DA), such as an Extron HDMI DA.

5. Connect the video outputs of the matrix switcher to the four sets of WindoWall Pro BNC

input connectors, or

If using HDMI inputs, attach each DA to one of the rear panel HDMI input connectors.

6. Connect the videowall displays to the RGBHV/YUV BNC output connector, the HDMI

output connector, or both.

7. Connect an active LAN Ethernet cable to the RJ-45 port on the WindoWall Pro rear

panel to establish a link to the network (see

LAN connector on page 7).

8. If serial control is desired, connect an RS-232 cable from the host to the Remote

RS-232/422 connector on the rear panel for serial control (see

Remote RS-232/422

connector on page 6).

9. Plug the WindoWall Pro, input devices, and output devices into grounded AC sources,

and power on all devices.

10. Install and set up the WindoWall Console software on your computer (see Setting Up

the WindoWall Console Software on page 11).

NOTE: Step 10 can be performed without the inputs, matrix switcher, or any other

hardware connected to the WindoWall Pro.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 89 90

Keine Kommentare

Extron electronics MGP Pro Series Betriebsanweisung Seite 11