Extron electronics TLP 710CV Einstellungsanleitung PDF herunterladen (Seite 3)

Product Category

Step 3 — Run all Cables

Run all cables necessary to support the AC connector, the cables stored in the cubby, and all planned AAP connectors.

Run the cables below the table and through the hole that was cut in Step 2. Leave enough slack in the cables to connect

or route them before the cubby is installed in the table. Leave enough space under the enclosure for the external power

supply and connection of AV cables and the network connection of the TLP 710CV.

Step 4 — Install Cable Retractors (Optional)

If required, Extron cable retractors should be installed in the

enclosure at this stage. For complete information about retractors

and how to install them, see the Retractors User Guide, which is

available from the Extron Website (www.extron.com).

Step 5 — Install Power Module (Optional)

NOTE: For models that do not include a power module, see

the Extron Website to select a power module that is

suitable for your location.

The power module takes up two or three AAP spaces, depending

on the model, and may be installed before or after the AAP

assembly is installed. It may be installed with AAPs on either side.

1. Secure the power module into position with #4-40 Phillips

head screws.

2. Run the cable or conduit to a convenient junction box.

Extron recommends the circuit be attached to a junction box

that is directly wired to the main circuit.

Step 6 — AAP Assembly

Install all desired cables into the cable pass-through AAPs

and install the AAPs into the Cable Cubby.

The simplest way to install the cables and AAPs is to

populate the AAP brackets outside the cubby and then

install the populated AAP shelf assembly into the cubby.

Install cables in the pass-through holes as shown in the

ﬁgure to the right.

TIP: Hand tightening the #4-40 nuts makes it easier

to place and secure the assembly inside the

enclosure.

Secure the power module

to the TLP 710CV frame

with Phillips head screws.

Rear Shelf Bracket

Front Shelf Brackets

1 2 3 4 5 6 7 8

Keine Kommentare

Extron electronics TLP 710CV Einstellungsanleitung Seite 3