6
TLP 710CV • Setup Guide (Continued)
Step 12 — Power on the TLP 710CV for the First Time
Power on all the devices connected to the TLP 710CV.
When the 12 VDC power supply or the PoE power
supply is switched on, the TLP 710CV will boot up
and, if a graphical user interface (GUI) has been
designed and loaded onto the touchpanel, that
screen will be displayed. If a GUI has not been
loaded, a plain blue screen will be displayed.
Front Panel Features
With the lid down, the screen, light sensor, and the
illumination LED are disabled. They are all activated
by opening the lid.
To see all the front panel features, remove the bezel,
using the Extron Removal Tool (see the figure to the
right). Place the flat edge into one of the slots on
the top edge of the screen (
i
in the figures below)
and pry the corner away from the touchpanel frame.
Move the removal tool to the other slot in the top
edge and release that corner. Slide the removal tool
along the side until the bezel separates from the
unit.
a
c
b
g
f
e
d
For a complete description of all these features and their function, see the TLP 710CV User Guide.
a
Light Sensor — monitors ambient light level and adjusts screen brightness.
b
LCD screen — has a 800x480 resolution with a touch overlay. Extron software is used to design and configure a graphic
user interface to display buttons, text, or icons, which have user-defined functions associated with them.
c
MTP Video Signal Adjustments—ThreeMTPsignaladjustmentsareavailableforS-video:luminancegain(VID/Y),
S-videochrominancegain(C),andsharpness(S).Forcompositevideosignals,theVID/Yadjustmentcontrolsthegain.
d
Reset LED — provides feedback about the mode status when the user presses the reset button.
e
Controller Communication LED — is unlit during normal operation. The LED blinks red if the connection to the IP
Link controller is lost.
f
Reset Button — allows the unit to be reset to one of four different modes.
g
Menu Button — activates the on-screen menus for calibrating the unit.
h
Speaker — one, placed at the back of the AAP enclosure, provides audible feedback for the user.
i
Bezel Removal Slots — allow removal of bezel, using Extron removal tool.
j
Illumination LED — provides light for cable cubby enclosure.
h
i
j
Extron
Extron
Insert the removal tool in the
notch at one top corner and
loosen the bezel away from
the screen.
Move the removal tool to
the second notch and
loosen the bezel away from
the screen.
Slide the removal tool along
one side until the bezel
separates from the unit.
a
b
c
(4 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern