
4
TLP 710CV • Setup Guide (Continued)
Step 7 — Install the AAP Assembly
1. From the underside of the Cable Cubby, gently push
the AAP shelf assembly into position at the desired
elevation.
TIP: Ensure there is enough space above the
AAP assembly for the lid to close completely
without cables or connectors contacting the
touchpanel.
2. Secure the AAP shelf assembly into position with the
provided Phillips head screws.
3. Tighten the nuts that secure the AAPs to the shelf
brackets.
Step 8 — Mounting the Enclosure
Mount the Cable Cubby in the table.
WARNING: The flanged edges of the trim ring are sharp. Exercise caution when the cubby is not installed in a table to
prevent personal injury.
CAUTION: The trim ring edges are soft and can easily be nicked or bent. Exercise caution when handling and mounting
the enclosure.
1. Remove the edge grommet protecting the edges of the trim ring and the plastic film on the finished surfaces.
CAUTION: Do not use isopropyl alcohol or other solvents to clean the Cable Cubby. Strong solvents will ruin some
finishes.
2. Carefully lower the TLP 710CV enclosure into the hole cut in the
table (see “Step 2 — Cut the Surface” on page 2). Ensure the trim
ring (
e
) is flush with the top of the table.
3. Under the table, attach the table clamps (
c
) to the pins on each
side of the TLP 710CV. It may be necessary to loosen the wingnuts
(
a
) and the Phillips head screws (
b
).
4. When the clamps are properly seated on the pins, tighten the
Phillips head screws until the clamp faces (
d
) are tightly secured
against the bottom of the table.
5. To prevent the screws from becoming loose, secure the wingnuts
against the table clamp bodies.
a
b
e
COMPUTER
AUDIO
Phillips Head Screws
(secure AAP Shelf
Assembly)
Tighten down
AAP Nuts.
Push assembly through
bottom of enclosure.
Large slot
provides tool
access to fasten
rear brackets.
b
a
c
Kommentare zu diesen Handbüchern